Drop-In Anchor 3/8" X 1-9/16"

Drop-In Anchor

• An Internally Threaded Expansion Anchor Complete With An Integral Expander Plug.
• This All-Steel Anchor Is Designed To Be Used In Solid Concrete, Hard Stone, And Solid Block.
• The Matching Setting Tool Drives The Internal Pre-Fitted Plug To Expand The Anchor Without Damaging The Internal Threads.
• Anchors Are Zinc Plated.
• Diameter: 3/8"
• Minimum Depth: 1-9/16"
• Thread Depth: 5/8"
• Drill Diameter: 1/2"
• Install With Setting Tool, Part No. 11336 . Installation Procedures Drill A Hole Into The Base Material To The Depth Of Embedment Required. The Tolerances Of The Drill Bit Used Should Meet The Requirements Of Ansi Standard B212.12. Do Not Over Drill The Hole Unless The Application Calls For A Sub Set Anchor. Blow The Hole Clean Of Dust And Other Material. Insert The Anchor Into The Hole And Tap Flush With The Surface. Using The Setting Tool, Set The Anchor By Driving The Tool Into The Anchor Until The Shoulder Of The Tool Is Seated Against The Anchor. If Using A Fixture, Position It, Insert Bolt Or Threaded Rod And Tighten. Minimum Thread Engagement Should Be At Least 2/3 Of The Anchor Thread Length.