Power Stud 3/8 X 2-1/4

Power-Stud® Wedge Anchor

• A One-Piece, Wedge Style Anchor Designed For Use In Concrete.
• The Anchor Diameter Is The Same As The Diameter Of The Hole For Faster Installation.
• Chamfered Threaded End Prevents Damage To The Threads During Installation.
• Carbon Steel Power Stud Anchors Are Bright Zinc Plated.
• Size: 3/8 X 2-1/4
• Minumum Embedment: 1-5/8"
• Thread Length: 1"
• The Length Shown Is The Overall Length Of The Anchor. Allow One Anchor Diameter For The Nut And Washer Thickness When Selecting A Length. Installation Procedures Using The Proper Diameter Bit, Drill A Hole Into The Base Material To A Depth Of At Least 1/2" Or One Anchor Diameter Deeper Than The Embedment Required. The Tolerances Of The Drill Bit Used Should Meet The Requirements Of Ansi Standard B212.15. Blow The Hole Clean Of Dust And Position The Power Stud. Drive The Anchor Through The Fixture Into The Anchor Hole Until The Nut And Washer Are Firmly Seated Against The Fixture. Be Sure The Anchor Is Driven To The Required Embedment Depth. Tighten The Anchor By Turning The Nut 3 To 4 Turns Or By Applying The Guide Installation Torque From The Finger Tight Position.